In the May 2001 issue, this column discussed the thermal conductivity of unfilled plastics. The interested reader may have noticed that the category of rubbers/elastomers was missing. This was not without reason. The user of these elastic materials should be aware that the final thermal resistance (which is, of course, from an engineering point of view, the more important … [Read more...]
Temperature and reliability in electronics systems – the missing link
To introduce the reliability requirements we face for the future, we focus on telecommunication as an example. Personal telecommunication is becoming increasingly integrated into our daily lives. However, we cannot take full advantage of the technology unless the telecommunication system is as dependable as a car. Just as turning the ignition key should produce the right engine … [Read more...]
Noise emission of telecommunication devices
Modern environmental requirements demand low noise levels for telecommunication cabinet products, especially when located in offices or urban areas. The spaces available are limited, and the power and electronics packaging density are increasing. Fans are commonly used to enhance the cooling of electronics by improving heat transfer due to higher air velocities. In this paper, … [Read more...]
Vapor Compression Cooling for High Performance Applications
Vapor compression refrigeration is being adapted to cool computer and telecommunications equipment in a limited number of high performance applications. Vapor compression can lift large heat loads and can heat sink at below ambient temperatures. Cold plates can offset high case-to-junction temperature gradients to keep high power integrated circuits from overheating and/or can … [Read more...]
Use of Naphthalene Sublimation Technique for Obtaining Accurate Heat Transfer Coefficients in Electronic Cooling Applications
The naphthalene sublimation technique has been demonstrated by a number of investigators to be an excellent method for obtaining heat transfer results [1,2] and a few have applied this technique to applications focused on electronic cooling [3-6]. These investigators have found that the mass transfer process can be set up with cleaner boundary conditions and can be studied more … [Read more...]
- « Previous Page
- 1
- …
- 459
- 460
- 461
- 462
- 463
- …
- 487
- Next Page »
