Introduction In 1995, a typical thermal design engineer was aware that removing heat was not going to get any easier in the next few years. A look back at the past ten years reveals that thermal management remained a challenging field. Fortunately, developments and improvements in thermal management hardware have assisted the electronics packaging community by enabling higher … [Read more...]
A Funny Thing Happened On The Way To The Heatsink
Introduction When faced with the task of calculating the temperature of an IC in a package, which has an external heat sink mounted to it, a thermal engineer usually obtains a values of three thermal resistances: ΘJC , the junction-to-case thermal resistance for the package, ΘCS , the case-to-sink thermal resistance representing the thermal interface material (TIM) between the … [Read more...]
Latest Developments In Thermoelectrically Enhanced Heat Sinks
Nomenclature Q Heat load (W) COP Coefficient of Performance I Electrical current (Amps) T Temperature (°C) R Electrical resistance (Ohms) Z TE Figure of Merit (1/K) where Z = α2 / (ρ λ) Greek Letters Δ Change in value θ Thermal resistance (°C/W) ρ Electrical resistivity (Ohm-cm) α Seebeck coefficient (V/K) λ Thermal conductivity … [Read more...]
Vibration Analysis For Electronic Equipment
This topic is rather esoteric and usually an afterthought in commercial and industrial applications. In military and defense electronics, it is one of the major drivers for design and product architecture early on in the design cycle with specific targets/budgets. As with junction temperature requirements in a thermal design, there are structural dynamic issues that need to be … [Read more...]
Using an Equivalent Heat Transfer Coefficient to Model Fins on a Fin
Many readers of ElectronicsCooling are probably familiar with the use of fin efficiency formulas to estimate the thermal resistance of the commonly used parallel plate fin heat sink. Given the heat transfer coefficient, h, acting on a fin and the dimensions of the fin, the thermal resistance of an individual fin is given by: where Af and η are the surface area and … [Read more...]
- « Previous Page
- 1
- …
- 47
- 48
- 49
- 50
- 51
- …
- 59
- Next Page »
